SYNCHRONIZATION PLUG-IN MODULE This synchronization module is specially designed for Datakom D-500, 700 MK2 controllers. It includes all necessary functionality for generator synchronization purposes. 1. ANALOG AVR CONTROL OUTPUT Structure: Isolated analog output, ±3 VDC Connection: 2 wires Output Impedance: 270 ohms Isolation Voltage: 1000 VAC, 1 minute Precision: 12 bits Rest point: Adjustable through program parameter Sweep Range: Adjustable through program parameter 2. ANALOG GOVERNOR CONTROL OUTPUT Structure: Isolated analog output, 0-10 VDC Reference: Battery negative Output Impedance: 1000 ohms Precision: 12 bits Rest point: Adjustable through program parameter Sweep Range: Adjustable through program parameter 3. DATALINK-CANBUS PORT Structure: CANBUS, isolated. Connection: 4 wires (DATALINK-H, DATALINK-L, GND, TERMINATION). Data rate: 250 kbps standard (adjustable between 50 and 500 kbps) Termination: 120 ohms resistor internally connected to DATALINK-H. The TERMINATION is to be connected to DATALINK-L in order to terminate the Datalink bus. Isolation voltage: 1000 VAC, 1 minute Common mode voltage: -0.5 VDC to +15 VDC, internally clamped by transient suppressors. Max distance: 200m with 120 ohm balanced cable IMPORTANT NOTES: The Datalink cable shield should be grounded from one end only. The Datalink bus should be terminated from both ends: 4. ANALOG LOAD SHARE SIGNAL Structure: Non-isolated analog input & output, 0-10 VDC Reference: Battery negative Output Impedance: 1000 ohms Precision: 12 bits Rest point: Adjustable through program parameter Sweep Range: Adjustable through program parameter WE DO NOT SHIP THIS PRODUCT TO USA AND CANADA